Nexug Industries Private Limited

The standard work at height kit as shown contains a Kestrel 2 fall arrest harness, a Twin clip loop lanyard, and an EN397 Industrial helmet. This kit comes stored in an Equipment bag.

Although these are the basic elements required for the work at height kit, we do understand these kits are very individual. Therefore, should you wish to purchase further items from our range to compliment your kit or change any element, please advise and we will assist you in your selection.

Specifications:

• Kits can be adapted at the users request.
• Please see individual products for specifications.

This High Access Rescue kit uses our A-B auto-brake descender in the system. The system is pre-threaded within a rope bag as required by EN341.

This system can be used as an escape/self rescue procedure, to rescue an injured person in a two man load, or as a pick-off system, lifting a fallen casualty from their lanyard, rope or sling etc.

This kit can come with 25m or 50m of rope.

We advise that the user be trained in use of this equipment.

The Kit Contains:

• Small rescue rope bag
• Rope 25m to 50m
• A-B Descender
• 3x Steel Karabiner’s
• 1x 20cm Twin eye sling
• 1x 240cm 25mm round superweb sling
• 2x Heavy duty rope/sling protectors.
• Safety knife and pouch

You can also add the equipment below to the kit to transfer it into a pick off rescue kit:

• Extension pole
• Rocker
• 1x 120cm round sling.
• 2x Karabiners
• 2x Std pulleys

The Rooftop Access Kit was developed to take advantage of using either a single or twin rope safety system. It can be used as a vertical safety fall arrest system on ladders, towers, tree’s etc. It can also be used as a work restraint or fall arrest system in rooftop areas where a single rope can be used to access an open edge, or a twin rope system to prevent pendulum movement.

There are no knots for the user to tie as this has been taken care of by either clipping the rope karabiner directly on to an anchor (EN795) or looping around a structure or girder then clipping back into the rope loop on the slider.

The access kit includes:

• Equipment holdall 35L
• Kestrel 2 harness
• 4 Gater alloy screw gate karabiners
• 2 Oval screw gate steel karabiners
• 2 Rockers
• 11m low stretch rope to required length
• 4 rope protectors
• 2 10cm twin eye sling

This system must be used from the front chest attachment only.
Training is highly recommended for this system so that the user understands its many uses.

Specifications:

• Each kit contains all the items shown in the picture with a either 25 or 50 meters of rope.
• As a work restraint/positioning system it will conform to EN358 and as a vertical back-up system EN353-2. Each individual item in the kit conforms to the correct EN standards and are compatible for this use. If a harness is not required because the client already has one this can be taken out as the kit can be used with any of the SAR full body harnesses or sit harness with the chest harness linked.

The standard work at height kit as shown contains a Kestrel 2 fall arrest harness, a Twin clip loop lanyard, and an EN397 Industrial helmet. This kit comes stored in an Equipment bag.

Although these are the basic elements required for the work at height kit, we do understand these kits are very individual. Therefore, should you wish to purchase further items from our range to compliment your kit or change any element, please advise and we will assist you in your selection.

Specifications:

• Kits can be adapted at the users request.
• Please see individual products for specifications.